Only the hellcat engine?? Not a better background like the old one? Damn! This is so ugly. Buttons to change modes look like disabled, and the top-bottom-right border looks so bad designed! RAM should fired that designer, it is a crappy job there.
Uconnect update I actually like… so far
- Thread starter Louk
- Start date
- Joined
- Dec 21, 2022
- Messages
- 540
- Gallery
- 12
- Reaction score
- 613
- Location
- Montana in the boonies
- Current Ride
- 2023 TRX 2025 Audi RS6 Avant
- Current Ride #2
- Porsche GT2 707 whp 2002, 2024 Hayabusa, 1971 Hemi Cuda 4 speed
Still have the BS RHO graphics as of last night...grrrrrrrr
- Joined
- Jan 30, 2023
- Messages
- 9
- Reaction score
- 3
- Location
- Missouri
- Current Ride
- 2022 TRX LVL-2
- Current Ride #2
- 1968 Mustang Convertible
No update yet for me either. And tbh, I’m less concerned with the graphics than I am with getting the functionality back. If they could just roll me back to before the great reset that’d be a ok with me. Want the gauges and latching aux switches to work (consistently) and fix whatever the hell happened to my suspension calibration.
Quick question for all you guys:
This message started to showing up this morning, and I know I have two recalls pending, but I think I’m okay with the turning signal, it works fine to me. But, has anyone had any issue after the dealer addressed the update for this recall? My GT350 had an update in the ECM for the ABS and at lower rpm (<1,000) it does a little rev. Not always, but it is annoying. Some people say that it is the computer re-learning, but I don’t remember this when I got it brand new with 11 miles in the clock. Do you recommend to take it or leave it? What could goes wrong if I leave the truck without that update? Does a recall have an expiration date?
This message started to showing up this morning, and I know I have two recalls pending, but I think I’m okay with the turning signal, it works fine to me. But, has anyone had any issue after the dealer addressed the update for this recall? My GT350 had an update in the ECM for the ABS and at lower rpm (<1,000) it does a little rev. Not always, but it is annoying. Some people say that it is the computer re-learning, but I don’t remember this when I got it brand new with 11 miles in the clock. Do you recommend to take it or leave it? What could goes wrong if I leave the truck without that update? Does a recall have an expiration date?
- Joined
- May 28, 2023
- Messages
- 2,795
- Gallery
- 298
- Reaction score
- 4,998
- Location
- North Idaho
- Current Ride
- 2023 Lunar Edition TRX
Leave it. I'm not doing any of those recalls because it involves a trip to the dealer. When I sell my truck, the new owner can get them done.
I had both of those done, no issues at all with the ABS Module Configuration one, but now a few months later, the left turn signal is worse than it was before now. Not sure I'll bother going back at this point.
- Joined
- Feb 16, 2022
- Messages
- 266
- Gallery
- 34
- Reaction score
- 282
- Location
- Castle Rock, CO
- Current Ride
- 2023 Ram TRX
The last few months have been terrible for my left turn stalk. Essentially every third turn it stays on.
I'd be thrilled if mine worked that much!
Did they use the updated part for this recall or just use the same part number and see if that one wasn’t have the issue? This is crazy man!
You’re probably right..
Still didn’t get the update.
No update for me either yet. Apparently I wasn’t lucky enough to be in the first wave
My left turn signal is worse now as well, has a loud cracking sound and still doesn’t reset.
Like many others, I went again through two more factory resets. I got the right truck back for a while after a couple of hours to see it's back to RHO on the next day.
@RamCares
Okay guys! This is going crazy now! Last Monday, I was driving the TRX and hit the Drive Modes to check the engine graphic and... Surprise Surprise! My graphic had the Hellcat engine back! Yey!!!! I notice something weird, like something was "weird" on that graphic; it was not well finished. I dont know guys, it was strange, but hey! The engine was there, right? Okay, I was so proud of my hellcat engine displaying again that next day I had my wife with me, I told her: "Hey honey, I have my cool hellcat engine graphic back, look"... and BOOM! The hellcat engine was gone, and the RHO was back! How the hell is that possible @RamCares. Please, ask your development team to stop playing games and fix this mess. It is not that hard, just release the last stable version for TRX owners. Cmon!
I also had the hellcat graphic then at next start up the rho was back.
Also on the performance page I attached, boost is no longer there and has been replaced with oil pressure. The picture is from before the latest update/mess up
TRX Forum Favs 👍
RAM TRX Forum Photos
RAM TRX Forum Photos
