What did you do to your TRX today?

[SCARd4Life]

There is a video comparing the Wix (best), various Frams (XG best), etc. For the life of me I can't find it. Shows the media, backing mesh, valves, seals, etc. From other posts, it appears that Wix makes the SRT filter. Will use either of those. Since the oil is like $50+, seems like using the best filter makes sense.

Thread 'Oil filter comparison' https://www.jeep392.com/threads/oil-filter-comparison.1011/

Found it! Was on the 392 forum.

 

[SRT Honey Badger]

Put in the cargo divider by Roll N Lock. Fits great with the Roll N Lock E series bed cover with remote.

 

[22’TRX]

Had my SCD leveling springs installed!

So… 37’s next? . It is a never ending rabbit hole once you start down that road, if you are anything like me.

 

[Erik]

Had my SCD leveling springs installed!

Did you have the geometry checked again after changing the springs? I'm going on Monday.

 

[Ranny_TRX]

Got tints & Xpel stealth installed. Pictures don’t do justice!

 

[Trx001]

I installed the J&L catch can today

Took me about 30 min. 20 of it was waiting for the engine to cool down after driving it just down the street for me to figure out which side to push on the stock clip ends to release without burning my hand lol - engine gets hot!

There was oil evident in the stock line at only 600 miles

Happy w the J&L

 

[Mr_Lurch]

AWE OFG Exhaust..sounds so much better in person!
View attachment 36429

Any drone with this? I get a terrible drone with the stock system in overdrive.

 

[CoJoe]

Got tints & Xpel stealth installed. Pictures don’t do justice!

Truck is looking good!!...What tint % did you go with? Windshield tinted too?

 

[CoJoe]

Got the windows tinted. I also put the clear ceramic on the windshield as I had it on the Raptor and it really helped with the heat here in Florida. I was a bit concerned to have the windshield done because of the issues of water getting behind the dash and messing up the electronics for the truck. The place I used was very familiar with that issue, took extra precautions to protect the under dash electronics and had done others before mine without a problem. Everything went perfectly with no problems.

I also added an Undercover Armor Flex bed cover.

How do you like you Undercover Armor Flex bed cover? I think that's the one I am leaning towards.

 

[Cali_TRX]

BD Reverse Lights

 

[Superbrowndude]

 

[SicilianDefense]

Stared at the window sticker dreaming of the day the dealer tells me it's arrived..

 

[wac45]

How do you like you Undercover Armor Flex bed cover? I think that's the one I am leaning towards.

I am very happy with it. I really like the LineX type finish on it and it is very close to level with the sides of the bed. It is also very easy to use when you want to open it up. When all the way open for full bed access it does not contact the cab. In that position it does block the rear window view (not that it mattered to me). The digital rear view camera takes care of the issue however if it matters.

I have noticed a couple of drops of water in the rear corners after washing. I think adding a small strip of weather insulation there would resolve that issue but I haven't done that yet.

I had this same model on my previous Raptor and was very satisfied.

I did find that I cannot use the Mopar bed divider because the clamps for the bedcover extend far enough down to prevent being able to attach the bed divider track. I don't know if this is the case with all tri fold bed covers or not.

 

[Alienhead]

I ordered wheels and tires. Same size just better than stock. I really did not like that a Sagebrush stick went through my side wall.

 

[Jb123]

Awesome setup man. I almost pulled thw trigger on these exact wheels but ended up going with the Fuel Covert.

 

[Alienhead]

Awesome setup man. I almost pulled thw trigger on these exact wheels but ended up going with the Fuel Covert.

The tires have arrived. The wheels should be here Monday. Once I get them on I will post pictures.

 

[KnightMare]

I did lil something something...

 

[CarbonFiber]

I did lil something something...

Where in Tarantino did you get that steering wheel?????

 

[CoJoe]

I am very happy with it. I really like the LineX type finish on it and it is very close to level with the sides of the bed. It is also very easy to use when you want to open it up. When all the way open for full bed access it does not contact the cab. In that position it does block the rear window view (not that it mattered to me). The digital rear view camera takes care of the issue however if it matters.

I have noticed a couple of drops of water in the rear corners after washing. I think adding a small strip of weather insulation there would resolve that issue but I haven't done that yet.

I had this same model on my previous Raptor and was very satisfied.

I did find that I cannot use the Mopar bed divider because the clamps for the bedcover extend far enough down to prevent being able to attach the bed divider track. I don't know if this is the case with all tri fold bed covers or not.

Right on... That's enough to convince me, I'll be ordering this model from @Johnny@JustBoltOns
Good to know about the digital rearview camera working with the cover folded up, I was wondering about that. Thanks man!

 

[KnightMare]

Where in Tarantino did you get that steering wheel?????

Steering wheel Dodge RAM TRX Carbon fiber/Perforated leather/Led screen - Aza Auto Wheel

Ergonomically grooved side grips are made with multiple premium materials for a more stable steering wheel control and for more comfortable driving Preserving the OEM groove patterns on the back of the stock steering wheel Premium quality stitching is available in many colors A choice of center...

azaautowheel.com