-
Featured
- #1,381
I wish I could say I spent good money on powder coating.Looks good! What did you use?
It's not a match to the bumper but its definitely an improvement
I wish I could say I spent good money on powder coating.Looks good! What did you use?
Quick questionInstalled this Paragoptics kit when I was doing my stereo but just sharing now after a quick night trip. Like driving a strip club.View attachment 41564View attachment 41562View attachment 41560View attachment 41561
No, I have 3 lights on all 4 doors. 2021 Level 2.Quick question
on the back doors below the door handles there were no lights to replace? The front doors had 3 lights to replace and rear doors only had 2 lights, so I had 2 left over? did your rear doors only have 2 lights to replace?
thx
Put in the cargo divider by Roll N Lock. Fits great with the Roll N Lock E series bed cover with remote.
What did you smoke your lights with?Truck things
View attachment 41589
Here is link to video as it was too large to post. Hope you can access. Thanks again to @Tom488 for his help!Show us where. Video would be great!
Nightshades spray. I found vinyl doesn’t handle Phx sun very well and the gloss doesn’t match the paint. So two coats of nightshades, two coats of 2k auto clear, wet sand and polish.What did you smoke your lights with?
Thanks, i have a level 2 also and only had 2? There was no harness that went to the spot by the handle? It went past it and to the map section, very oddNo, I have 3 lights on all 4 doors. 2021 Level 2.
I drop off my truck at the dealer since I got an email from Ram to have air bags checked.
How was the install?Installed this Paragoptics kit when I was doing my stereo but just sharing now after a quick night trip. Like driving a strip club.View attachment 41564View attachment 41562View attachment 41560View attachment 41561
Not difficult, but slightly uncomfortable and time consuming. Take the old light boards out and put the red ones in. Unfortunately there are 19 of them, and the radio screen and all four door panels need to come off to gain access. Removing those parts without breaking anything takes a weird combination of both care, and brute force.How was the install?
Jesuuuusss - that's a stump. Did you have some help from a backhoe?This more what the TRX did, than what was done to the TRX... Size of stump was a surprise....
No backhoe. TRX torque and a saw with an old chain for strategic cuts. TRX pulled from alternating angles - took a couple hours all in.Jesuuuusss - that's a stump. Did you have some help from a backhoe?
RAM-TRX Vendors